Christie J series 2.4kW Guide d'installation télécharger pdf (Page 12)

2-2 J Series 2.0, 2.4, and 3.0 kW Setup Guide

020-100751-01 Rev. 1 (10-2011)

Section 2: Installation and Setup

2. Align the lens interface plate with the lens mount. Align the lens electrical connector with the mating

connector on the lens mount. Fully insert the assembly straight into the lens mount opening without

turning. Press using your hand as shown in Figure 2-2.

NOTE: When installing the lens, ensure that the

lens is not inserted at an angle, as this can cause damage.

FIGURE 2-2

3. Remove the front lens cap.

4. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the lens

assembly in place. See Figure 2-3.

FIGURE 2-3

5. For added stability such as motion applications, fasten the security screws provided with the lens mount.

Refer to Figure 2-4.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Pas de commentaire

Christie J series 2.4kW Guide d'installation Page 12