Christie CP 2210 Guide d'installation

CP2210Setup Guide020-100524-04

CP2210 Setup Guide 1-1020-100524-04 Rev. 1 (05-2014)1 IntroductionThis manual is intended for professionally trained operators of Christie high-bright

1-2 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Introductionnot exposed to cumulative radiation levels exceeding the government guidelines for you

IntroductionCP2210 Setup Guide 1-3020-100524-04 Rev. 1 (05-2014)Wear Protective ClothingNever open the lamp door unless you are wearing authori

CP2210 Setup Guide 2-1020-100524-04 Rev. 1 (05-2014)2 Installation and SetupThis section provides information and procedures for positioning and insta

2-2 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Installation and Setup2.3.3 Adjustable Feet For many cinema installations, the cinema projector is

Installation and SetupCP2210 Setup Guide 2-3020-100524-04 Rev. 1 (05-2014)• GPIO: Connect external I/O devices, such as the Christie ACT, for r

2-4 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Installation and Setup• OFF: Not detected.• Red: Detected communication problems etc.• Green: Dete

Installation and SetupCP2210 Setup Guide 2-5020-100524-04 Rev. 1 (05-2014)2.4 Position the Cinema Projector • All installation procedures must

2-6 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Installation and Setup2.5 Adjust Tilt and Level the Cinema Projector Auto LampLOC™ must be run any

Installation and SetupCP2210 Setup Guide 2-7020-100524-04 Rev. 1 (05-2014)3. Connect the cable from the TPC to the connector on the rear panel

2-8 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Installation and Setup The lens seals the projection head, preventing contaminants from entering t

Installation and SetupCP2210 Setup Guide 2-9020-100524-04 Rev. 1 (05-2014)1. Install the M-MALM according to the instructions provided with the

2-10 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Installation and Setup• Always wear Christie approved protective safety clothing (P/N: 59-8900-09

Installation and SetupCP2210 Setup Guide 2-11020-100524-04 Rev. 1 (05-2014)1. Connect one end of the cinema projector power cord to the AC rece

CP2210 Setup Guide 3-1020-100524-04 Rev. 1 (05-2014)3 Connect Devices to the cinema projectorThis section provides information and procedures for conn

3-2 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Connect Devices to the cinema projector3.2 Connect a Communications Device The RS232 PIB port loc

Connect Devices to the cinema projectorCP2210 Setup Guide 3-3020-100524-04 Rev. 1 (05-2014)NOTE: All SCCI inputs require a pulse input of 50ms

CP2210Setup Guide020-100524-04

3-4 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Connect Devices to the cinema projectorAs shown in the tables, each available pairing of pins (±)

Connect Devices to the cinema projectorCP2210 Setup Guide 3-5020-100524-04 Rev. 1 (05-2014)3.5 Connect Devices to the 3D ConnectorThe 3D connec

CP2210 Setup Guide 4-1020-100524-04 Rev. 1 (05-2014)4 Adjust the ImageThis section provides information and procedures for adjusting the cinema projec

4-2 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Adjust the Image4.3 Basic Image AlignmentThis procedure ensures that the image reflected from the

Adjust the ImageCP2210 Setup Guide 4-3020-100524-04 Rev. 1 (05-2014)It is recommended that top/bottom boresight be completed before horizontal boresig

4-4 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Adjust the Image1. When top/bottom boresight is complete, adjust the image at the left and right s

Adjust the ImageCP2210 Setup Guide 4-5020-100524-04 Rev. 1 (05-2014)4.7 Adjust DMD Convergence UV EXPOSURE! Protective UV glasses must be worn when pe

4-6 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Adjust the Image4.10 Electronic Screen MaskingYou can use the masking tool to correct image edge b

CP2210 Setup Guide 5-1020-100524-04 Rev. 1 (05-2014)5 OperationThis section describes how to operate the CP2210 cinema projector. 5.1 Turn the Cinema

NOTICES COPYRIGHT AND TRADEMARKS Copyright ©2014 Christie Digital Systems USA, Inc. All rights reserved.All brand names and product names are tradema

CP2210 Setup Guide 6-1020-100524-04 Rev. 1 (05-2014)6 MaintenanceThis section provides information and procedures for performing cinema projector main

6-2 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Maintenance6.4 Inspect the Lamp Always disconnect from AC and wear authorized protective safety ge

MaintenanceCP2210 Setup Guide 6-3020-100524-04 Rev. 1 (05-2014)6.5.2 Clean the Lamp ReflectorInspect the mirror surface (reflector) for cleanli

6-4 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Maintenance6.7 Inspect and Clean Lamp BlowerNOTICE! DO NOT bend the impeller blades or loosen the

MaintenanceCP2210 Setup Guide 6-5020-100524-04 Rev. 1 (05-2014)g. With the lamp removed, visually inspect the reflector for dust. If necessary,

6-6 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Maintenance11. Software Adjustments. In the Advanced Setup: Lamp History window, tap the Add Lamp

MaintenanceCP2210 Setup Guide 6-7020-100524-04 Rev. 1 (05-2014)6.10 Replace the Air Filter Use only high efficiency Christie approved filters.

6-8 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Maintenance6.11 Replace the Lens1. Tap and hold the red power button on the TPC Main panel to tu

MaintenanceCP2210 Setup Guide 6-9020-100524-04 Rev. 1 (05-2014)10. For added stability, secure the cap screws provided on the lens mount. If yo

CP2210 Setup Guide 7-1020-100524-04 Rev. 1 (05-2014)7 TroubleshootingIf the cinema projector does not appear to be operating properly, note the sympto

7-2 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Troubleshooting7.3 Lamp Suddenly Turns Off•Tap Menu > Advanced Setup > Lamp Power/LiteLOC Se

TroubleshootingCP2210 Setup Guide 7-3020-100524-04 Rev. 1 (05-2014)7.8 Cannot Establish Communication with cinema projectorVerify all input dev

7-4 CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Troubleshooting7.14 Display is Not Rectangular• Verify the cinema projector is level and the lens

TroubleshootingCP2210 Setup Guide 7-5020-100524-04 Rev. 1 (05-2014)7.19 The Display is Unstable• Verify that the input device is connected pro

Japanph: 81-3-3599-7481South Koreaph: +82 2 702 1601For the most current technical documentation, please visit www.christiedigital.com USA – Cypressp

Table of ContentsCP2210 Setup Guide i020-100524-04 Rev. 1 (05-2014)1: Introduction1.1 Cinema projector Labels and Marking ...

ii CP2210 Setup Guide020-100524-04 Rev. 1 (05-2014)Table of Contents4.4 Adjust Offset.....

Table of ContentsCP2210 Setup Guide iii020-100524-04 Rev. 1 (05-2014)7.17 Data is Cropped from Edges...........