Christie DWU675-E Manuel d'utilisateur télécharger pdf (Page 11)

E Series 675/775 Serial Commands Technical Reference Information 7 of 53

020-000576-01 Rev. 1 (10-2012)

(DSV) DIGITAL VERT SHIFT READ/WRITE: WRITE ONLY

SUBCODE

DESCRIPTION OF USE

Valid range for vertical position is 0 to 100:

At 0 the display area is moved as far as possible to the top, at 50 the display area is vertically centered,

and at 100 the display area is moved as far as possible to the bottom. The image must be “zoomed out”

(Digital Zoom) before this function can be used. “Digital Horz Shift” will be disabled if Digital Zoom

has not been applied. Default value is 50.

EXAMPLES:

(DSV50)

(WRP+SLCT) GEOMETRY CORRECTION READ/WRITE: R/W

SUBCODE

SLCT

DESCRIPTION OF USE

Select the type of Geometry Correction to be applied to the image:

"Off/Basic" are available options when the optional Dual Processor Warp Module is not installed, and

"Off/Basic/Curve/Rotate" are available options when the optional Dual Processor Warp Module is

installed.

- Off: No geometry correction is applied to the image.

- Basic: When Warp Module is not installed, keystone and pincushion can be adjusted. When Warp

Module is installed, keystone, pincushion/barrel and 4-corner can be adjusted.

- Curve: When Warp Module is installed, curve and 4-corner can be adjusted. Not available without

the warp module.

- Rotate: When Warp Module is installed, rotate and 4-corner can be adjusted. Not available without

the warp module.

EXAMPLES:

(WRP+SLCT 1) Enable basic settings

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 56 57

Pas de commentaire

Christie DWU675-E Manuel d'utilisateur Page 11