Christie CP2000-M Guide d'installation télécharger pdf (Page 18)

2-10 CP2000-M/MR Setup Guide

020-100205-03 Rev. 1 (05/09)

Section 2: Basic Operation

• Use PCF: Activate to use a pre-defined PCF for this source and prohibit further Channel

adjustments (the PCF components of Source, Color Space, Gamma, LUT-CLUT and Target Color

will disappear), then select the desired PCF from the PCF File menu. Deactivate to adjust the

Channel settings - this is currently recommended for all cinema use.

When to Use a PCF?

The availability of functions in the Channel: Page 1 menu depends on whether you choose to

utilize pre-defined configuration files (PCFs) already downloaded to projector memory, or whether

you prefer to implement your own settings. PCFs can be created using the DLP Application then

downloaded to the projector. By enabling the Use PCF checkbox a pre-defined PCF can be

selected and implemented. Most applications; such as cinema, post production and “alternative” or

“non-cinema” displays require 1 or more display parameters be individually adjusted. In this case,

clear the Use PCF checkbox.

• 3D Control: Activate to use 3D Control. For more information, refer to 2.12

Channel: 3D Control

• Lamp Power: Enabled only when LiteLOC™ is disabled. Lamp Power indicates what per centage

of power to supply to the lamp, automatically overriding any LiteLOC™ setting that may be in

effect. This causes the bar graph to rise or fall as Lamp Power is increased or decreased, but the

LiteLOC™ red line and Set values will not change unless Set is pressed (defining a new LiteLOC™

setting and enabling LiteLOC™ checkbox).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 73 74

Pas de commentaire

Christie CP2000-M Guide d'installation Page 18