Christie CP2000-M Guide d'installation télécharger pdf (Page 53)

Section 3: Installation & Setup

CP2000-M/MR Setup Guide 3-11

020-100205-03 Rev. 1 (05/09)

3.10 ADJUSTING TILT AND LEVELING

For an ideal installation, the lens surface should be centered and parallel to the screen - this orientation

helps to ensure optimized lens performance with minimal offset. Choose a sturdy mounting surface. If

this position is not possible (such as when the projector is significantly higher than the center of the

screen), it is better to rely on offset rather than extra tilt.

3.10.1Adjusting Tilt

IMPORTANT! The front-to-back tilt of the projector must not exceed 15°. This limit ensures safe lamp

operation and proper position of the liquid cooling reservoir. For best optical performance, avoid

tilting the projector excessively. Use vertical offset of the lens instead.

Before adjusting tilt, ensure the projector is centered as much as possible to the theatre screen. Check

with theatre personnel for the degree of screen tilt, or measure this incline with a protractor at the

screen. Then tilt the projector to closely match the screen tilt angle by extending or retracting the

projector’s 4 adjustable feet.

3.10.2Adjusting Feet/Leveling

To adjust the height and level of the projector, extend or

retract the feet by rotating them (Figure 3-10). Once

the required adjustment is made tighten the lock nut.

The 2 back feet measure 203mm (8”) in order to

achieve a 15° tilt when necessary. NOTE: When

installing the CP2000-M/MR on the rack stand (108-

282101-xx or 108-272101-xx) the foot lock brackets

(119-100101-xx) must be installed for safety purposes.

3.10.3Carrying/Moving the Projector

2 people are required to safely lift and carry 1

projector a short distance. Titling the projector

excessively should be avoided as it can introduce air

bubbles within the coolant hoses, which can lead to an

air lock.

CAUTION

Disconnect from AC for these initial alignments. Images are not yet needed.

FIGURE 3-10 LEVELING

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 73 74

Pas de commentaire

Christie CP2000-M Guide d'installation Page 53