Christie CP2000-M Guide d'installation télécharger pdf (Page 50)

3-8 CP2000-M/MR Setup Guide

020-100205-03 Rev. 1 (05/09)

Section 3: Installation & Setup

3.8 CONNECT SOURCES AND INITIAL POWER UP

Although an image is not required at this time, it is recommended external cinema servers and sources

be connected. Refer to 3.9

Connecting Sources. Before igniting the lamp for the first time, it is

essential the following steps are completed to ensure successful communication with the projector:

1. Assign the projector with a unique IP address. Each projector is given a default IP address;

however, if connecting the projector to an existing network it must be assigned a new IP address.

For first time installations, assign the IP address in the Configuration/Administrator menu, via

the CDP.

2. In the Configuration>Administrator>Serial Baud Rate menu, set the baud rate to match the

external device connected (i.e., an automation controller). The projector’s default baud rate is 9600

Kbps.

3. From the CDP Lamp menu, select Change Lamp and define the type of lamp installed, serial

number and number of hours logged on the lamp (if any).

4. With all components installed and connected, power-up the projector, as described in

2.2

Powering Up the Projector.

5. Turn the lamp ON via the CDP.

6. Perform LampLOC™ alignment immediately on the newly installed lamp. This ensures the

lamp is positioned correctly to achieve maximum light output.

7. Perform initial optical alignment in order to optimize images displayed on screen. These

adjustments must be done before boresight adjustments. Refer to 3.11

Basic Image Alignment for

instructions.

8. In rare instances, the installer may have to adjust 1 or more optical components.

Refer to 3.13

Adjustable Fold Mirror & Convergence Adjustments for instructions.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 73 74

Pas de commentaire

Christie CP2000-M Guide d'installation Page 50