Christie CP2000-X Guide d'installation télécharger pdf (Page 17)

Section 2: Installation and Setup

CP2000 Setup Guide 2-5

020-100070-01 Rev. 1 (10/08)

1. Open both pedestal doors (Figure 2-5).

2. From the projection head, open the rear side door on the operator's side and open the lamp door

(Figure 2-5).

FIGURE 2-5 OPEN PROJECTOR FOR ACCESS

3. SET BALLAST AC INPUT SWITCH: Before connecting the ballast to AC, set the ballast’s AC input

switch to match the AC available at the site—toggle left for nominal 200 VAC supplies, and toggle

right for 400 VAC supplies. The factory default is 200 VAC.

4. Ballast ‘RS-232’ Cable: Connect the ballast's ‘RS-232’ cable 34-002075 to Panel B (9-pin),

routing through the small rectangular access hole in the front underside of the projection head

(Figure 2-6 Connect Ballast RS-232 and Interlocks to Projection Head). A second connector on

Panel B is pre-connected to Panel C. Any third connector is a non-functional spare.

5. Ballast Interlock Cable: Connect the ballast's interlock cable 34-002007 to Panel C (9-pin),

routing through the small rectangular access hole in the rear underside of the projection head

(Figure 2-6 Connect Ballast RS-232 and Interlocks to Projection Head). A second connector on

Panel C is pre-connected to Panel B and the remaining third connector is a non-functional spare.

FIGURE 2-6 CONNECT BALLAST RS-232 AND INTERLOCKS TO PROJECTION HEAD

NOTE: These cables also connect to the fire alarm interlock and dedicated outlet (both pre-connected

at manufacture).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Pas de commentaire

Christie CP2000-X Guide d'installation Page 17