Christie CP2000-X Guide d'installation télécharger pdf (Page 21)

Section 2: Installation and Setup

CP2000 Setup Guide 2-9

020-100070-01 Rev. 1 (10/08)

IMPORTANT! Ball joint must move freely. If necessary, hand tighten

with 9/64" Allen key.

• With 3/16" Allen key, secure the NEGATIVE (-) BLACK lamp lead

and the two igniter harnesses to the side of the connector nut (Figure

2-13 Secure Lamp Lead and 2 Igniter Wires).

IMPORTANT! Secure lamp lead FIRST on connector, then remaining

two igniter wires on TOP.

At this point, the lamp pre-wiring is complete. Leave lamp accessible

for now.

CONNECT TWO COOLING HOSE ENDS (PEDESTAL-TO-HEAD)

During operation, a closed loop of flexible tubing circulates cooling liquid stored in the pedestal to

critical electronic components located in the front compartment of the projection head (Figure 2-14

Liquid Cooling Loop). Looking into the pedestal, the liquid will circulate counterclockwise.

FIGURE 2-14 LIQUID COOLING LOOP

FIGURE 2-13 SECURE LAMP

EAD AND 2 IGNITER WIRES

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 63 64

Pas de commentaire

Christie CP2000-X Guide d'installation Page 21