Christie CP2000-X Guide d'installation télécharger pdf (Page 30)

2-18 CP2000 Setup Guide

020-100070-01 Rev. 1 (10/08)

Section 2: Installation and Setup

1. Remove the pair of rack protector posts from the rear of the pedestal.

2. Remove the required horizontal rack covers (security plates).

3. Rack-mount the desired equipment within the pedestal.

4. Re-install the pair of rack protector posts. Keep extra covers.

Do not modify any CP wiring or lead dress during installation. Ensure the added device does not

interfere with normal CP operation.

• Power normally connects to the projector's internal outlet (208 VAC models) or is hard-wired to the

TB2 terminal block (400 VAC models).

NOTE: Internal power connection is not possible if incoming AC feed is 4-wire 3-phase only, as the

internal outlet or TB2 terminal has no power in this case.

FIGURE 2-25 CONNECTING AN INTERNAL CINEMA SERVER/SOURCE

FIGURE 2-26 CONNECTING AN INTERNAL NON-CINEMA (DVI) SOURCE

NOTE: The DVI ports are single-link ports for single-link cable/connectors only. Using as a dual-link

pair requires a special adapter (not currently available).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 63 64

Pas de commentaire

Christie CP2000-X Guide d'installation Page 30