Christie CP2000-M Guide d'installation Page 29

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 74
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 28
Section 2: Basic Operation
CP2000-M/MR Setup Guide 2-21
020-100205-03 Rev. 1 (05/09)
2.13 ADMIN MENU
The 7 Admin menus offer a broad range of options used primarily for defining how the projector will
respond to incoming sources in the given environment, or for adjusting a major system parameter
affecting overall performance.
2.13.1 Admin: Source Menu
Incoming sources can vary in their current resolution and original aspect ratio. The projector must be
able to respond to the countless possible combinations, projecting full images of the desired size,
content and proportion in every case. This consistency is achieved by creating a variety of source files
in projector memory, each of which indicates the following for the projector:
Incoming resolution (# pixels across, # pixels top-to-bottom)
Offset desired (i.e., amount of data to discard. Rare.)
•Desired aspect ratio (i.e., the original display format to be recovered)
In rare cases the content distributor may include this source information as part of a pre-defined PCF
(applied by using the PCF in the projector), alternatively these variables can be defined from the
Admin: Source menu. With a good collection of assorted source files available in memory, the proper
file can then be quickly chosen from within the Channel: Page 1 menu for implementation in the
projector whenever a matching input signal is encountered. NOTE: For any source, the projector relies
on Source file settings, as well as Screen file settings. Refer to2.13.2
Admin: Screen Menu, on page 2-
23.
FIGURE 2-12 ADMIN: SOURCE MENU
A
Offset: Amount to discard; adjust XY
settings until desired offset achieved
E
Test: Preview settings in display without saving
B
Source: Incoming format; adjust XY
settings until desired resolution achieved
F
Restore: Cancel unsaved source settings &
return to previously saved settings
C
Source: Select source file to modify from
drop-down list
G
Aspect Ratio: Select a preset aspect ratio
(width to height proportion) or enter a custom
value
D
Save
Vue de la page 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 73 74

Commentaires sur ces manuels

Pas de commentaire