Christie CP2000-M Guide d'installation télécharger pdf (Page 62)

4-4 CP2000-M/MR Setup Guide

020-100205-03 Rev. 1 (05/09)

Section 4: Maintenance

4.3 LENS REPLACEMENT

4.3.1 REMOVE LENS

1. Power down the projector. Allow the fans to cool the lamp before unplugging the projector. If

necessary, a lens can be swapped out while the projector is running, but this can result in dust

being drawn into the projector. Avoid if possible.

FIGURE 4-3 LENS ASSEMBLY

2. Install the lens cap (Figure 4-4, 1) and release the lens clamp by pushing it up (Figure 4-4, 2).

FIGURE 4-4 RELEASE LENS CLAMP

3. If necessary, remove the 2 capscrews securing the lens to the lens mount (Figure 4-4, 3).

4. Pull the lens out of the lens mount. The lens, motorized zoom and focus connectors disconnect

when the lens is pulled straight from the mount.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 73 74

CP2000-M/MR 1
TABLE OF CONTENTS 3
1 Introduction 7
1.1.2 Key Features 8
2 Basic Operation 9
2.1.2 AC/POWER PRECAUTIONS 10
2.1.3 LAMP PRECAUTIONS 10
DANGER 10
2.2 POWERING UP THE PROJECTOR 11
Section 2: Basic Operation 12
2.3.1 Projector Power States 13
ENTER to view 14
MENU at any time to 14
EXIT once to 14
2.5 CHANNEL MENU 16
2.6 LAMP MENU 19
2.7 LENS CONTROL MENU 20
2.8 STATUS MENU 22
===== ===== 23
2.11 MAIN MENU 24
CP2000-M/MR Setup Guide 2-17 25
2-18 CP2000-M/MR Setup Guide 26
2.12 CHANNEL: 3D CONTROL 27
2.12.2 Hardware Setup 28
2.12.3 3D Instructions 28
2.13 ADMIN MENU 29
2.13.2 Admin: Screen Menu 31
FIGURE 2-14 CROPPING 32
FIGURE 2-15 LETTERBOX 32
2.13.3 Admin: MCGD Menu 33
2.13.4 Admin: TCGD Menu 35
2.13.5 Admin: Lamp Menu 37
2.14 WORKING WITH THE LAMP 38
Using LiteLOC™ 39
FIGURE 2-20 ENABLE LITELOC 39
 if desired 40
2.15 CINEMA OPERATION 41
2.16 NON-CINEMA OPERATION 42
3 Installation & Setup 43
3.1 POSITION THE PROJECTOR 44
CP2000-M/MR Setup Guide 3-3 45
FIGURE 3-3 CONNECT DUCTING 46
(M-MALM) INSTALLATION 47
3.6 INSTALL LENS(ES) 48
3.7 INSTALL LAMP 49
3-8 CP2000-M/MR Setup Guide 50
3.9 CONNECTING SOURCES 51
WARNING 52
3.10.1Adjusting Tilt 53
3.10.2Adjusting Feet/Leveling 53
3.11 BASIC IMAGE ALIGNMENT 54
3.12.1 Adjust Offset 55
CAUTION 55
CP2000-M/MR Setup Guide 3-15 57
3.13.1 DMD Convergence 58
3.13.2 Fold Mirror Adjustment 58
4 Maintenance 59
4.2 FILTER REPLACEMENT 61
4.3 LENS REPLACEMENT 62
4.3.2 INSTALL LENS 63
5 Troubleshooting 65
5.3 CINEMA DISPLAYS 66
5.4 NON-CINEMA DISPLAYS 67
Section 5: Troubleshooting 68
5.4.12 Display is “Noisy” 69
6 Specifications 71
Section 7: Specifications 72
6.3 POWER REQUIREMENTS 73
6.4 LAMPS 73
6.5 REGULATORY 74

Commentaires sur ces manuels

Pas de commentaire

Christie CP2000-M Guide d'installation Page 62

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Christie CP2000-M