Christie CP2000-ZX Guide d'installation télécharger pdf (Page 18)

2-8 CP2000-ZX Setup Guide

020-100098-04 Rev. 1 (06-2009)

Section 2: Installation & Setup

Installing a Pluggable Type B Connection

There must be easy access to the current protection device or breaker in the building. Follow these guidelines:

 Use 10AWG or 8AWG wiring: the distance between the wall circuit breaker and the projector must

not exceed 20 metres using 10AWG cables or 30 metres using 8AWG cables.

 The socket-outlet is installed near the equipment and is easily accessible.

 The plug can be used as the device disconnect and is near the unit and easily accessible.

1. A small electrical access plate is located in the lower right corner of the projector faceplate. Loosen the two

screws and slide the plate forward to expose the terminal block underneath. See Figure 2-14.

2. Remove the knockout plate (four screws) located in the bottom right corner of the front bezel.

3. Connect the AC power source to the terminal block, beginning with the ground lead first. See Figure 2-15

for wiring details. Tighten screws securely.

4. Once all cables are connected, secure the knockout plate (four screws) and the bottom access panel (two

screws) over the terminal block.

Figure 2-13 Nema-L630A 250V Male Power Plug (116-102104-01)

Actual Length 1.5 Meters

Figure 2-14 Remove the Knockout Plate

Figure 2-15 Steps to Connect AC Power to Terminal Block

White

Black

Green

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

Pas de commentaire

Christie CP2000-ZX Guide d'installation Page 18