Christie CP2000-ZX Guide d'installation télécharger pdf (Page 23)

Section 2: Installation & Setup

CP2000-ZX Setup Guide 2-13

020-100098-04 Rev. 1 (06-2009)

8. Ensure the ground connection from the UPS input to the ground stud is secure.

9. Re-attach the side panel and plug an appropriate UPS that meets the required input specifications into the

IEC connector on the auxiliary panel. Refer to Section 6: Specifications in the CP2000-ZX User Manual

(020-100006-xx).

10. Re-connect main power, turn on the UPS power and ensure that the projector operates normally.

2.4 Adjusting Tilt and Leveling

Use of the supplied safety strap is MANDATORY to prevent the projector from

tipping forward while being adjusted for tilt or when the optional auxiliary lens is installed.

Disconnect the projector from the AC for these initial alignments. Images are

not yet needed.

For an ideal installation, the CP2000-ZX lens surface should be centered and parallel to the screen. This

orientation helps to ensure optimized lens performance with minimal offset. Choose a sturdy mounting surface

that allows for this. If this position is not possible (such as when the projector is significantly higher than the

center of the screen), it is better to rely on offset rather than extra tilt.

2.4.1 Adjusting Tilt

Important! For best optical performance, avoid tilting the projector excessively. Use vertical offset of the

lens instead.

Before adjusting tilt, make sure the projector is centered as much as possible to the theatre screen. Check with

theatre personnel for the degree of screen tilt, or measure this incline with a protractor at the screen. Tilt the

projector to closely match this screen tilt angle by extending or retracting the projector’s four adjustable feet.

NOTE: The front-to-back tilt of the projector must not exceed 15°. This limit ensures safe lamp operation and

proper position of the liquid cooling reservoir in the projector.

2.4.2 Adjusting Feet / Leveling

Located on the bottom of the projector are four adjustable feet. To adjust the

height and level of the projector, extend or retract the feet by rotating them.

Once the required adjustment is made, tighten the lock nut. See Figure 2-19.

Make sure the projector’s rear safety strap is in place before adjusting.

2.4.3 Carrying / Moving the Projector

Four or more people are required to safely lift and

hand-carry one

projector a short distance. It is strongly recom-

mended the projector be kept as level as possible when carried

up stairs or when lifted onto a table.

Keep the projector as level as possible when lifting or carrying the projector.

Avoid tilting the projector excessively, especially on the right side (air filter side), which can

introduce an air bubble within the coolant hoses that can lead to an air lock.

Figure 2-19 Adjust Feet

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 57 58

Pas de commentaire

Christie CP2000-ZX Guide d'installation Page 23