Christie CP2000-X Guide d'installation télécharger pdf (Page 16)

2-4 CP2000 Setup Guide

020-100070-01 Rev. 1 (10/08)

Section 2: Installation and Setup

NOTE: There is no need to adjust leveling and/or tilt at this point. Wait until all other components are

mounted/installed. For more information, refer to 2.4

Adjust Tilt and Leveling.

FIGURE 2-3 ADJUST FEET

INSTALL TPC

1. Attach the Touch Panel Controller, pre-assembled with its

ball joint base and mounting arm, to the matching ball

joint base secured at the rear of the projector (Figure 2-4

Typical TPC Mount).

2. Connect to the TPC cable routed through the nearby hole

in the projector rear. The other end of this cable is pre-

connected to the internal Ethernet hub and the 24V power

supply.

If desired, you can mount the TPC and its 24V power supply

elsewhere at the site. Route the TPC cable through either the

rear or front hole on the projector. Cap unused hole.

CONNECT PRE-INSTALLED CABLING (PEDESTAL-TO-

HEAD)

Numerous cables are pre-installed within the pedestal and must be routed up to the underside of the

projection head, where they connect to one of three panels (or two IEC power sockets).

NOTE: For all cable connections, keep cable ties that have been trimmed at manufacture. Remove

temporary untrimmed ties that have "tails".

FIGURE 2-4 TYPICAL TPC MOUNT

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

Pas de commentaire

Christie CP2000-X Guide d'installation Page 16