Christie CP2000-X Guide d'installation télécharger pdf (Page 48)

4-2 CP2000 Setup Guide

020-100070-01 Rev. 1 (10/08)

Section 4: Maintenance

exposed to cumulative radiation levels exceeding the government guidelines for your area. 2) Be

aware that some medications are known to increase sensitivity to UV radiation.

This projector must be installed on the floor only and operated in an environment with the correct

operating range specifications. For more information, refer to Section 8: Specifications, outlined in

the CP2000 User’s Manual.

4.1.3 AC/POWER PRECAUTIONS

Projector installation requires that an electrician hard-wires a 3-phase (Y) feed and a separate 15A

single-phase feed from the pedestal toe to the AC supply in your building. Use only the correct

pedestal for your geographic area. Operate the projector at the specified voltage.

Do not allow anything to rest on the power cord. Locate the projector where the cord cannot be walked

on or rolled over. Never operate the projector if the power cable appears damaged in any way.

Do not overload power outlets and extension cords to avoid fire or shock hazards.

Only qualified service technicians are permitted to open any enclosure and only if AC has been fully

disconnected at both wall breakers.

4.1.4 LAMP PRECAUTIONS

WEAR PROTECTIVE CLOTHING

Never open the lamp door unless you are wearing authorized protective clothing, which is included in

the Christie Protective Clothing Safety Kit (#598900-095). Recommended protective clothing includes

- but may not be limited to - protective gloves, latex lab gloves, double-layer 0.040" acetate face

shield, and a quilted ballistic nylon jacket or welder's jacket.

NOTES: 1) Christie's protective clothing recommendations are subject to change. 2) Any local or

federal specifications take precedence over Christie recommendations.

WARNING

Fire Hazard. Keep hand, clothes and all combustible material away from the

concentrated light beam of the lamp.

WARNING

Do not attempt operation if the AC supply and pedestal are not within the specified

voltage range.

Shock Hazard. Disconnect from AC before opening any enclosure. Disconnect at both

wall breakers.

WARNING

Never attempt to remove the lamp directly after use. The lamp is under increased

pressure when hot and may explode, causing personal injury and/or property damage.

Allow to cool completely.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 63 64

Pas de commentaire

Christie CP2000-X Guide d'installation Page 48