Christie CP2000-X Guide d'installation télécharger pdf (Page 47)

CP2000 Setup Guide 4-1

020-100070-01 Rev. 1 (10/08)

4 Maintenance

This projector is designed for safe and reliable operation. However, safe operation is not assured by

design alone; installers, service technicians, trained operators and all other users must maintain a safe

environment at all times. Please read through and understand all warnings and precautions before

attempting to operate the projector.

4.1 WARNINGS AND GUIDELINES

4.1.1 LABELS AND MARKINGS

Observe and follow any warnings and instructions marked on the projector.

The exclamation point within the equilateral triangle indicates related operating/

maintenance instructions in the documentation accompanying the projector.

The lightning flash and arrowhead symbol within the equilateral triangle indicates

non-insulated "dangerous voltage" within the projector's enclosure that may be of

sufficient magnitude to constitute a risk of electric shock.

4.1.2 GENERAL PRECAUTIONS

NOTES: 1) The American Conference of Governmental Industrial Hygienists (ACGIH) recommends

occupational UV exposure for an 8-hour day to be less than 0.1 microwatts per square centimeters of

effective UV radiation. An evaluation of your workplace is advised to assure employees are not

WARNING

Never look directly into the projector lens or at the lamp. The extreme high brightness

can cause permanent eye damage.

Position all cables where they cannot contact hot surfaces or be pulled or tripped over.

Opening or removing a projector cover requires a qualified service technician.

WARNING

For protection from ultraviolet radiation, keep all projector housings intact during

operation. Protective clothing and safety goggles are recommended.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 63 64

Pas de commentaire

Christie CP2000-X Guide d'installation Page 47