Christie CP2000-X Guide d'installation télécharger pdf (Page 33)

Section 2: Installation and Setup

CP2000 Setup Guide 2-21

020-100070-01 Rev. 1 (10/08)

In rare cases where additional tilt is needed, you can utilize the rear extender legs as described

below.

IMPORTANT! For best optical performance, avoid tilting the projector excessively. Instead use

vertical offset of the lens.

1. Remove the rear bottom panel (two top screws, two bottom tabs) from the CP pedestal

(Figure 2-30).

FIGURE 2-30 OPEN REAR OF PROJECTOR

2. Use a low-profile scissor jack to elevate the rear of the projector.

FIGURE 2-29 ADJUST 4 FEET FOR TILT AND LEVELING

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 63 64

Pas de commentaire

Christie CP2000-X Guide d'installation Page 33