Christie CP2000-X Guide d'installation télécharger pdf (Page 19)

Section 2: Installation and Setup

CP2000 Setup Guide 2-7

020-100070-01 Rev. 1 (10/08)

8. Connect lamp leads (Figure 2-9 Route Lamp Leads Up and Connect Positive (+) White).

At the igniter:

• Ensure igniter door is open. From the ballast in the pedestal, route the main black and white lamp

leads through the nearby hole in the underside of the projection head (Figure 2-9 Route Lamp Leads

Up and Connect Positive (+) White).

• Route the NEGATIVE (-) BLACK lamp lead through the hole in the lamp cooling compartment wall

(Figure 2-9 Route Lamp Leads Up and Connect Positive (+) White).

• Connect the POSITIVE (+) WHITE lamp lead to the POSITIVE (+) igniter terminal. This terminal

also has a small PCB attached-stack this on top of the lamp lead (Figure 2-9 Route Lamp Leads Up

and Connect Positive (+) White).

• Close and lock the igniter door.

FIGURE 2-9 ROUTE LAMP LEADS UP AND CONNECT POSITIVE (+) WHITE

WARNING

Make sure the PCB directs to the back and remains at least 3/4" from the high-voltage

terminal (with braid connection).

Route all igniter wires AWAY from 9-pin and 15-pin connectors.

Twist both ballast cables twice-per-foot.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 63 64

Pas de commentaire

Christie CP2000-X Guide d'installation Page 19