Christie CP2000-X Guide d'installation télécharger pdf (Page 55)

Section 4: Maintenance

CP2000 Setup Guide 4-9

020-100070-01 Rev. 1 (10/08)

3. Tighten set screws in both negative and positive lamp connectors (Figure 4-2 Secure bulb at

cathode (-) and anode (+) connectors).

IMPORTANT! Proper electrical contact prevents resistance in the lamp connectors.

If you accidentally touch the quartz body of the lamp with your bare hands, clean it as described in 4.3

Maintenance and Cleaning.

FIGURE 4-2 SECURE BULB AT CATHODE (-) AND ANODE (+) CONNECTORS

CHECK LEADS

Ensure the anode (+) lead between the lamp and igniter is well away from any projector metal, such as

the reflector or firewall.

CLOSE COOLING COMPARTMENT AND LAMP DOOR

The projector will not operate unless the louvered door is locked shut.

TURN BREAKERS ON

At the projector's breaker panel, turn all breakers ON.

WARNING

Leads too close to metal parts will cause arcing during starting pulse. This is a SAFETY

HAZARD and the lamp may not ignite.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 63 64

Pas de commentaire

Christie CP2000-X Guide d'installation Page 55